Updating install script and removing unneeded configuration file

config/rc.local

@@ -1,24 +0,0 @@
-#!/bin/sh -e
-#
-# rc.local
-#
-# This script is executed at the end of each multiuser runlevel.
-# Make sure that the script will "exit 0" on success or any other
-# value on error.
-#
-# In order to enable or disable this script just change the execution
-# bits.
-#
-# By default this script does nothing.
-
-# Print the IP address
-_IP=$(hostname -I) || true
-if [ "$_IP" ]; then
-  printf "My IP address is %s\n" "$_IP"
-fi
-
-# Set up IP forwarding and NAT routing
-echo 1 > /proc/sys/net/ipv4/ip_forward
-iptables -t nat -A POSTROUTING -j MASQUERADE
-
-exit 0

installers/common.sh

@@ -160,7 +160,6 @@ function default_configuration() {
     sudo mv $webroot_dir/config/hostapd.conf /etc/hostapd/hostapd.conf || install_error "Unable to move hostapd configuration file"
     sudo mv $webroot_dir/config/dnsmasq.conf /etc/dnsmasq.conf || install_error "Unable to move dnsmasq configuration file"
     sudo mv $webroot_dir/config/dhcpcd.conf /etc/dhcpcd.conf || install_error "Unable to move dhcpcd configuration file"
-    #sudo mv $webroot_dir/config/rc.local /etc/rc.local || install_error "Unable to move rc.local file"
     # Generate required lines for Rasp AP to place into rc.local file.
     # #RASPAP is for removal script